|
04-03-2014, 05:01 PM
|
#1
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
RE-thinking up grades
So- I got a quote and FIVE new wheels and tires is going to run about 950.00. Thus, I may be getting cold feet. So- what are folk's thoughts? One issue I have is uneven tire wear which I have not resolved (what is causing it). However, I've got two tires now with the issue as I switched the tire from the wheel that is the culprit ( driver front) to the rear curb side but last season I got the same issue on the tire I switched to the front. Anyway- I thought going to fourteens would be a good idea and , also, switching to radials in the process. Cant remember why I thought going to fourteens would be a good idea but I think it had to do with getting radials. I raised trailer last season by three inches.
So- if I dont switch- I will likely have to buy two new 13" tires anyway. Any thoughts on ADVANTAGES to going to the fourteens?---I'm thinking the fifteens will be a bit too close to each other on the tandem.
Rick
__________________
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-03-2014, 05:51 PM
|
#2
|
Site Team
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,544
|
The advantage in going to a larger sized wheel/tire combo is an increased load carrying capability. This should reduce running temperatures in the tires which tends to weaken them, leading to tire failure. Larger tires will have a lower rotation speed too, which may reduce the wear on them some.
If you are going to replace all the tires anyway, I don't think the extra cost of the larger wheels will be that much, and the cost increase per tire is pretty low.
What's off putting is the total cost of a set of five. However, I'm looking at spending around $1000 for a new set of tires for my F150, so I see this as just the cost of periodic maintenance.
I DO wish you could figure out what is causing the uneven wear though, and fix it.
- Jack
__________________
__________________
Hi-Lo 1707T - Tire Minder TPMS on Tow Vehicle and Trailer, 300W Solar Battery Charger, Equal-i-zer WDH, Progressive Dynamics Converter, Fan-Tastic Fan, LiFePO4 battery 12V DC Electrical System
2014 F150 Platinum 4x4 3.5L EcoBoost SCrew
|
|
|
04-03-2014, 06:49 PM
|
#3
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
Thanks, Jack. I wish I could figure it out, too. I guess I will take it back to the guy who did the camber last year and have him look at it one more time. My fear is the axle is so weak that it keeps re-bending and it will just get worse- and require new axles.... and I think it was you who looked into new and stronger axles at one point- wasn't it? I just got a "newer" truck- only 39k on it, but the Goodyear Wranglers on it look a bit rough so I hear you about a new set of tires ------I priced michelins out around 1k, also.
Going over to get my old prodigy II installed in the new truck tomorrow- then I can haul it around and decide what to do. Maybe I will just go two new 13" tires for the season and see what happens.
Well, hell. Its only money, right??
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-03-2014, 10:04 PM
|
#4
|
Site Team
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,544
|
Yup, it's only money. That $1K you mentioned is what I came up with for Michelins for my truck too. I have Goodyear Silent Armor on there now, but they look fairly worn at about 46,000 miles. I suppose I can't complain since I think they are 50,000 mile tires. And, they've never had a flat. The Michelins I was looking at have a 70,000 mile treadwear warranty.
- Jack
|
|
|
04-04-2014, 05:29 PM
|
#5
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
Went in this morning and got a much better quote from dealer. So- he tried putting on15s but they touched each other. Went ahead and installed 14s on one side to see how it would work. Its close on top and side but it clears. How much do the axles/tires move up and down going over bumps? pics posted: Thoughts appreciated. pic 1 new 14s; pic 2 old 13s; pic 3 13s at top/side; pic 4 14 top/side
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-04-2014, 05:35 PM
|
#6
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
More pics:
1st is 13s-next two the fourteens.
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-04-2014, 06:36 PM
|
#7
|
Site Team
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,544
|
I can't imagine the 14" wheels/tires would give you any upper clearance problems with a 3" lift. If the new tires are less than 6" in diameter larger than the old tires (a less than 3" increase in radius), they won't be any closer to the roof of the wheel well than the old ones were before the lift.
From your pictures, it looks to me like your tire diameter increase is 2-3" or less? That would put the top of the tires no more than 1.5" higher than the old 13" tires are now.
- Jack
|
|
|
04-04-2014, 06:56 PM
|
#8
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
I will have to look closer and measure tomorrow. I think my concern is more the tire width. There is room from top of tire to top of wheel well. It's the outside top that concerns me, where it would " go into" wheel well. I suppose as long as there is no wwobblewhich would be bad by itself- it should work. 5 wheels and tires for 500.00 is not a bad deal . Guess I can get them on and off if they did.
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-04-2014, 10:33 PM
|
#9
|
Site Team
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,544
|
I found my tire width increased only about 0.9" by going to a larger, D-rated tire on a 15" wheel. However, your increase may be more since you are changing your wheel diameter too. (Mine stayed the same, although I went from a 5" width wheel to a 6" width wheel).
Anyway, I've had no wheel well/tire interference with the new size.
I agree, your wheels should not wobble. I wonder if you could see the camber problem if someone else drove your TV-trailer while you watched from the outside? (In a vacant parking lot of course.)
An axle is not really too expensive. As I recall, when mine was replaced (a 3500# torsion axle), it was in the neighborhood of $350 from Dexter. But, my service contract/warranty paid for it.
- Jack
|
|
|
04-07-2014, 08:04 PM
|
#10
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
@ Jack. First off- thanks for sticking with me on this thread. I trust your experiences and insight. Anyway- went back and crawled around some more and I really dont think the side wall is that much closer to the edge of the well than the thirteens are, it just looks scarier because with the lift the thirteens are now BELOW the well where the fourteens start to go back up and into it. So I told them to go ahead.....but not to throw away my old tires and wheels. The trailer is starting to get pretty damn high, now. No problem getting under there to service it, thats for sure. Hopefully I dont pick up too much extra wind drag. I'll take some pics and post when they get it done. Thanks for the suggestions.
Rick
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-07-2014, 11:26 PM
|
#11
|
Site Team
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,544
|
You MAY get a bit more wind drag, but you're really not increasing your frontal area. It will sit a bit higher than the roof of your tow vehicle, but I doubt you'll really notice much difference.
Don't forget to adjust the ball height for the increase in tongue height, so the trailer still rides level.
Personally, I think with my trailer lifted and with the larger tires, I think it tows better.
- Jack
|
|
|
04-25-2014, 11:04 PM
|
#12
|
Member
Join Date: Nov 2013
Location: Gilbert AZ
Posts: 70
|
Rick, if you really get tired of tread wear put on some torsion axles.
I have used scores of these on my FMX trailer ramps with zero issues.
4 bolts and that is all that is needed to hold them in place. I use grade 8 bolts with metal lock nuts though.
Images and links are attached in case others are interested
Trailer Torsion Axles
Andy Jones' Suspended Ramp
FMX Ramps - Suspended Ramp
Other (ugly) Rick
|
|
|
04-26-2014, 11:18 PM
|
#13
|
Senior Member
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
|
I'm pretty sure that I already have two torsion axles on there. New ones may be in order, though.
__________________
2201 TL
2010 Nissan Titan king cab SE
4x4
|
|
|
04-27-2014, 07:23 PM
|
#14
|
Moderator
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
|
Quote:
Originally Posted by hilltool
I'm pretty sure that I already have two torsion axles on there. New ones may be in order, though.
|
Yes, it is a rubber suspension.
__________________
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|