Hi,
I have a 92 19 ft Towlite. I want to permanently mount scissor jacks on it.
I bought 24 in RV scissor jacks at Harbor Freight. They are large and I am not sure where to mount them. Would some please tell me where to mount them?
Will I have to drill through the floor to add them? Thanks for your help.
Lincow

I replied to your post several days ago, you must have missed it.

Here it is again: "On our 2310H the stabilizers are welded to the frame. The rear ones are just forward of the bumper and the front ones are roughly three feet back from the front corner of the box."

You could drill through the frame and bolt them on, but I think welding them on would be better.

__________________
Great Wife, Joyce
2010 2310H Hi-Lo
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU

Thanks sorry I missed your post
Linda

even though factory placement of the scissor jacks are sometimes at the outward edges of the frame(in the rear) I would place them as close to the cable lift pulleys as possible. This would prevent the typical can't get the door to close syndrome and less frame flex. you can bolt them to the frame with 1/4 or 5/16 bolts just in case they get damaged, so you can replace them

__________________
robobd
1988 22l
1999 ford f250 7.3 diesel

I was wanting to bolt them but I don't think there is any clearance between the frame and the floor. I am going to add a new cork floor so I could hide it. I am hoping cork will warm the floor some.
Linda

Don't bolt them to the floor, it isn't strong enough, they have to be mounted to the frame in some way.
On my 95 there are small pieces of angle welded from the frame to the center support and the stabilizer jacks are bolted to them.
On the 2209 there are plates welded to the underside of the frame and the jacks are bolted to them both are factory installed.

__________________
Rich
------------------------------------
(215TL) - 1995 21' TowLite
(2209T) - 2009 22' TowLite
99 Ford Explorer 4DR 4X4