Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 
 


Electrical Systems, Charging and Solar Electrical components and wiring, batteries, charging systems, generators and solar topics.
Reply
 
Thread Tools Search this Thread Display Modes
 
Old 05-12-2018, 01:12 PM   #1
Member
 
Join Date: May 2018
Location: Missouri
Posts: 4
Default Loud hum when electric hooked up

Just bought a 1995 18' Towlite. We have it set up at home now to renovate it. However, when I plug in the 120v I hear a loud hum coming from the converter box. When we inspected it pre-buy, he had the electric hooked up and it worked fine w/out a hum so either the converter suddenly went bad or something else is wrong.

Originally we had a 25' 12/3 extension cord to hook up to the nearest outlet but it was suggested that the 12 gauge wire may be too thin and is causing the hum. So I upgraded to a 10/3 but am still getting the hum. The wire running to the outlet may be 12 gauge. Basically I want to make sure I'm chasing the correct rabbit hole......so what power is needed to run to the camper? Is there anything else I should be looking at?
__________________

thompsonjams is offline   Reply With Quote
Old 05-12-2018, 04:40 PM   #2
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

The hum is probably coming from the transformer in the converter. It is a normal noise put out by the plates vibrating from the alternating current. The material that holds the plates together may have dried out over time. I don't know if there is a good way to quiet it down. They used to be held together with bolts but now they are glued. Replacing the converter is probably your best solution and it isn't a difficult job. There are a couple of options for doing that. Unless you are using the A/C or a microwave when plugged in you only need a normal extension cord and a 15 amp outlet. If you use the A/C you will need a 30 amp outlet and the heavy duty cord.
__________________

__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 05-12-2018, 06:37 PM   #3
Senior Member
 
Join Date: Jul 2010
Location: central Virginia
Posts: 581
Default HiLo problems

On my HiLo there is also a cooling fan in the converter that you can hear when it comes on. It comes on when the converter gets hot and shuts off when it cools down. The next time you get the hum, shut off all the circuit breakers one at a time and see if the hum goes away. There could be something on one of the AC circuits loading down the converter. Let us know what you find out.
__________________
Jim L & Faye
2805C
2003 Silvarado diesel crew cab
2017 Silvarado, crew cab 1500 6.2L gas w/ 8 speed tranny
central VA
JIM L is offline   Reply With Quote
Old 05-13-2018, 08:40 AM   #4
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

Jim L, don't you think the fan would come on when there is a load on DC rather than AC, such as the fridge in DC mode or when the battery is in bad need of a charge.
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 05-13-2018, 10:07 AM   #5
Senior Member
 
Join Date: Jul 2010
Location: central Virginia
Posts: 581
Default HiLo problems

Rich; Since the main job of the converter is to change AC to DC I agree with you that the most heat is generated when a heavy load is on the DC side. He might try pulling the fuses one at a time to see if there is a heavy load on one of those circuits. He also should have the battery checked to see if that is the cause due to it being defective.
__________________
Jim L & Faye
2805C
2003 Silvarado diesel crew cab
2017 Silvarado, crew cab 1500 6.2L gas w/ 8 speed tranny
central VA
JIM L is offline   Reply With Quote
Old 05-13-2018, 07:46 PM   #6
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

Quote:
Originally Posted by JIM L View Post
Rich; Since the main job of the converter is to change AC to DC I agree with you that the most heat is generated when a heavy load is on the DC side. He might try pulling the fuses one at a time to see if there is a heavy load on one of those circuits. He also should have the battery checked to see if that is the cause due to it being defective.
Anything is possible. I have seen where a lot of people have had the transformer hum and it didn't seem to be much to do with the amount of load placed on it as I recall. I have never seen any recommended ways to silence it. It should be a simple fix outside of replacement. Finding a replacement may be difficult. You could inquire here to see if they can help you:BestConverter - Converters, Inverters, Electrical Supplies, Electronics
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 05-13-2018, 10:46 PM   #7
sam
Senior Member
 
Join Date: Mar 2010
Location: Niagara Falls,NY
Posts: 4,062
Default Purchased our converter from Best Converter.

Have the old model # so they can advise you. Fast shipping and great tech support.
sam is offline   Reply With Quote
Old 05-14-2018, 07:35 AM   #8
Member
 
Join Date: Oct 2016
Location: carolina usa
Posts: 27
Default

I had a hum in my 99 towlite and charged my half dead battery and it went away. wound up replacing the battery b/c it wouldn't hold a charge
kirby is offline   Reply With Quote
Old 05-20-2018, 01:40 PM   #9
Gone Traveling
 
Join Date: Oct 2017
Location: Maui Hawaii
Posts: 47
Default The noise indicates an ungrounded system

Quote:
Originally Posted by RichR View Post
The hum is probably coming from the transformer in the converter. It is a normal noise put out by the plates vibrating from the alternating current. The material that holds the plates together may have dried out over time. I don't know if there is a good way to quiet it down. They used to be held together with bolts but now they are glued. Replacing the converter is probably your best solution and it isn't a difficult job. There are a couple of options for doing that. Unless you are using the A/C or a microwave when plugged in you only need a normal extension cord and a 15 amp outlet. If you use the A/C you will need a 30 amp outlet and the heavy duty cord.

Make sure the three prongs on electical plug are properly connected. check inverter terminals for build up of carbon ( darkened) clean with pencil eraser. or sand. check ALL GROUND WIRES SUPPLYING INVERTER
__________________

davidmaui is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Hi-Lo Trailers Worldwide or any of its affiliates. This is an independent, unofficial site.


All times are GMT -5. The time now is 08:58 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010
×