Pulley Sizes
I have searched the forum and only found the exterior dimensions of the pulleys for my 31 ft. Hi-Lo. I want to replace all the composite pulleys with aluminum ones. Some of them are already busted and have fallen on the ground below the camper upon lifting. What I am looking for is the center diameter for the bolt that goes through the center of the pulleys. My camper is at my son's property (where no one actually lives). I want to gather all the parts for the lift system to rebuild it before I go out to where it is. All the cable and related hardware has already been ordered. Just need to order the pulleys. Thanks for any help!:D:D:D:D:D
|
pulleys ...me too
hey when you find out about the aluminum pulleys would you let me know where you got them from and what they cost. That sounds like a good thing to do. I also have a 31 footer (2004) and have done several mods to it already. Drop me a line and I'll tell you what I have done.
TC:D |
drop me a line
hey Khan1960 I forgot to give you my email address...it is...LNT123@ATT.net
TC:p |
I also have a 31 footer! She’s been great!
|
Pulleys
Quote:
|
Quote:
|
how many
Richard do you remember how many pulleys of each size that it took to do a complete replacement?
|
Pulleys
Hi Savage, if I remember correctly I used 16 of the 5RRX8 and there were four of the 4JX69 saddle type. You should be able to get an exact count by crawling underneath the trailer, they are all exposed. One note the new pulleys don't squeeze the cable like the old ones, I could not find any with the narrow profile like the old ones, but I haven't had any problems with the new type. I don't remember if I mentioned, but I did use stainless steel cable for the replacement. The new pulleys had brass bushings, so they should long lasting.
|
pulleys
thanks for the info on the pulleys...so tell me where did you get the stainless steel cable and what lenghts were involved and where did you get them....what other hardware was needed to complete the rebuild. How did you jack it up in order to do the job. I would like to see some photos of this if they are available...thanks:)
|
Savage there's a great writeup about how to do the job
here |
I found one of the old composite pulleys in pieces in the back of my truck. I glued it back together and the bore diameter is 1/2". Haven't found the replacement pulleys yet, but am still looking for them. I am working 6 days a week right now, so i don't have a lot of spare time. Thanks for the reply!
|
Thanks Richard! I'll have to do some research!
|
Where did you buy the pulleys? We have to replace so we are doing the whole trailer so we will not have this happen again! We need the bottoms the tops look good!
|
All times are GMT -5. The time now is 10:59 AM. |
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010