Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 
 


General Hi-Lo camper discussion The perfect place to discuss your Hi-Lo camper
Reply
 
Thread Tools Search this Thread Display Modes
 
Old 06-08-2011, 05:35 AM   #1
Member
 
Join Date: Apr 2011
Posts: 8
Default Floor

Thea section of the floor in the bathroom of my 86 HI LO has rotten out. Any tips on how to replace it without removing the sewer tank??
__________________

rhbauer78 is offline   Reply With Quote
Old 06-08-2011, 06:13 AM   #2
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

Welcome to the forum. You happen to be in luck, floor replacement was just discussed here a few days ago. Look here:http://www.hilotrailerforum.com/f27/...oor-soft-1035/

There have been many topics discussed over the past, just go to search and enter a word or phrase and you may get lots of information. If you don't find it, there are lots of members that are willing to give you help.

Rich
__________________

__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 06-09-2011, 10:43 AM   #3
Member
 
Join Date: Apr 2011
Posts: 8
Default Floor information

Thanks for the info on replacing the floor in the bathroom. One more guestion
Is there anyway to remove the toilet flange from the wast tank. To put a new floor down I think it needs to me removed. Also where are the metal floor joist located on a 86 fun chaser Any info will be a help

Richard
rhbauer78 is offline   Reply With Quote
Old 06-09-2011, 05:07 PM   #4
Senior Member
 
JMDoering's Avatar
 
Join Date: May 2010
Location: Idaho
Posts: 586
Default

Richard,

On both of our Hi-Lo's, the flange is threaded to the waste tank, and is pretty easy to remove.

Regarding the "metal floor joists," AKA frame members, unless I'm completely misunderstanding your question, you should be able to locate by climbing under the trailer and looking.

Jim
__________________
1967 17' Hi-Lo Bon Voyage (1967-1969)
1969 19' Hi-Lo Bon Voyage (1969-2011)
2004 27' Hi-Lo TowLite (2010-present)
2015 Chevy Tahoe LTZ
JMDoering is offline   Reply With Quote
Old 06-10-2011, 02:34 PM   #5
Member
 
Join Date: Apr 2011
Posts: 8
Default

Thanks to everyone for all the information, A great help for this old boy (80)
Am leaving Sunday for Acadia National Park. It is one of my Hi Lo's favorite places. Richard
rhbauer78 is offline   Reply With Quote
Old 06-10-2011, 08:00 PM   #6
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

Our Hi-Lo likes it there also. Have a great time. Be sure to hit the Trenton Bridge Lobster Pound.
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 06-11-2011, 08:46 AM   #7
Senior Member
 
Join Date: Feb 2011
Location: kentland,in 47951
Posts: 196
Send a message via Yahoo to robobd
Wink hi rhbauer78

Hi, i am robobd, and i just replaced my floor on my 88 22L to see where your floor joists are, crawl under the trailer from the back or side. let me start over, first determine what parts of your floor is bad. I used a larger flat end punch, and used my hand to push down on the whole floor to determine all the soft spots, then I used a magic marker to out line the soft areas. I then measured from the back wall to the edge of the soft spots I marked, then I added two more inches to it. I then measured from my street side wall (which was bad on my hi-lo) to the edge of the soft line , then I crawled under and measured under the trailer to see how far over was the floor joists, went back inside and transfered over the lines where the joists were. remember there is an inch difference (wider) from your inside measurement. to make sure, measure 3 times, and cut one time. I also went under and drilled up right next to the joist on my short side to determine how far over to cut, then measured from the inside, added a 1/2" to determine where the center of the stud is. marked where the cut needed to be , I used an osolating cutting tool from harbor freight (39.00) and cut a 1/4" depth at a time so I would not cut my black water tank. please read my other post on soft floor.
If you have any questions, pleas ask no matter how small it may seem, an unkown answer could be the difference between $!.00 or a $1000.00 if not knowing how to do it!
__________________
robobd
1988 22l
1999 ford f250 7.3 diesel
robobd is offline   Reply With Quote
Old 06-26-2011, 12:36 PM   #8
Member
 
Join Date: Apr 2011
Posts: 8
Default floor reply

Just want to say a great big thanks for all the help I received. Sure makes life easier. Richard
rhbauer78 is offline   Reply With Quote
Old 06-27-2011, 12:48 AM   #9
sam
Senior Member
 
Join Date: Mar 2010
Location: Niagara Falls,NY
Posts: 4,051
Default Replacing vinyl flooring

Today our HiLo goes in to the floor place to have a professional install,new vinyl. Here is what the installer told us/is going to do. Old vinyl will be left in place.Entire floor will be skimcoated and new vinyl will be glued down. Not enough clearance to use subfloor. Only used sub floor to make a patch around toilet/rotted floor,hubby did this part of the repair. This is my christmas present to my self. Must have been good!!!! sam
__________________

sam is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Hi-Lo Trailers Worldwide or any of its affiliates. This is an independent, unofficial site.


All times are GMT -5. The time now is 04:28 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010
×