Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 
 


General Hi-Lo camper discussion The perfect place to discuss your Hi-Lo camper
Reply
 
Thread Tools Search this Thread Display Modes
 
Old 04-30-2011, 02:14 PM   #1
Member
 
Join Date: Apr 2011
Posts: 6
Default Help with Brakes?

I just purchased a 2005 Hi-Lo 17' camper and I also installed a Tekonsha P3 brake controller. After hitching the camper and powering up the controller it says that no trailer is attached. The brake lights and the turn signals work, so the 7 way was installed correctly. I pulled out on the road and when I push the braking lever on the P3 controller, it says no trailer attached and there is no braking occurring.

My son has the same controller in his truck and the very same scenario is occurring, so I am confident the controller I just installed in my truck is installed correctly.

Does anyone have any suggestion as to where I should start looking on the trailer? I don't see any fuses in the fuse box for the electric brakes....

Any suggestions?


Travis
__________________

jwwphoto is offline   Reply With Quote
Old 04-30-2011, 02:44 PM   #2
Senior Member
 
PopRichie77's Avatar
 
Join Date: Aug 2010
Location: Quakertown, PA
Posts: 1,074
Send a message via AIM to PopRichie77
Default

Some Hi-Lo's have a DC circuit breaker in the battery box. Check for it., and reset. Next pull the break away cable and see if the brakes go on full, you need a good battery in the trailer, for the break away to work the brakes. This will tell you if the trailer brakes and wiring in the trailer are good. Do not leave it pulled very long. If the brakes hold then the problem is with the 7 way plug and the trailer wire. Any of the newer manuals in the Reference Library have the brake electric schematic.
__________________

PopRichie77 is offline   Reply With Quote
Old 04-30-2011, 03:08 PM   #3
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

DO NOT pull the breakaway switch with the trailer plugged into the tow vehicle unless you want to buy a new brake controller to replace the one you just burned out. Tekonsha gives that warning in their instructions.
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 04-30-2011, 03:13 PM   #4
Senior Member
 
PopRichie77's Avatar
 
Join Date: Aug 2010
Location: Quakertown, PA
Posts: 1,074
Send a message via AIM to PopRichie77
Default

Good add vice Rich I definitely for got that you can not do that with some controllers..
PopRichie77 is offline   Reply With Quote
Old 04-30-2011, 04:37 PM   #5
Member
 
Join Date: Apr 2011
Posts: 6
Default

Thanks, I am guessing, that there is a broken wire somewhere between the axle and the 7 way plug. I just got to figure out who to bring it to.
jwwphoto is offline   Reply With Quote
Old 04-30-2011, 05:35 PM   #6
Member
 
Join Date: Apr 2011
Posts: 6
Default

Rich, I am N1JWW and drive a 2008 Tacoma.....

Jwwphoto
jwwphoto is offline   Reply With Quote
Old 04-30-2011, 08:17 PM   #7
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

CQ, CQ, de K3EXU

Is there a Morse code font on this laptop?

Nice to meet you N1JWW!
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 04-30-2011, 08:26 PM   #8
Site Team
 
JackandJanet's Avatar
 
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,527
Default

Quote:
Originally Posted by jwwphoto View Post
Thanks, I am guessing, that there is a broken wire somewhere between the axle and the 7 way plug. I just got to figure out who to bring it to.
Can't you just probe the 7-pin plug with a voltmeter to see if there is voltage between the brake positive (+) slot and ground if someone else (your Wife perhaps) sits inside and applies the brakes? This would tell you immediately if the fault was in the trailer or the tow vehicle.

The fact that the trailer brake lights work seems to imply that the fault could be in the trailer brake wiring itself. I think pulling the pin on the breakaway switch with the tow vehicle disconnected and a side of the trailer jacked up so you can try to spin the wheel(s) is a good bit of advice too.

One of the things I've found I don't like in the Hi-Los is the reliance on household wire nuts to join wires. Why couldn't they have used good automotive connectors?

- Jack
__________________
Hi-Lo 1707T - Tire Minder TPMS on Tow Vehicle and Trailer, 300W Solar Battery Charger, Equal-i-zer WDH, Progressive Dynamics Converter, Fan-Tastic Fan, LiFePO4 battery 12V DC Electrical System
2014 F150 Platinum 4x4 3.5L EcoBoost SCrew
JackandJanet is offline   Reply With Quote
Old 05-01-2011, 06:10 AM   #9
Senior Member
 
PopRichie77's Avatar
 
Join Date: Aug 2010
Location: Quakertown, PA
Posts: 1,074
Send a message via AIM to PopRichie77
Default

- Jack
Quote:
One of the things I've found I don't like in the Hi-Los is the reliance on household wire nuts to join wires. Why couldn't they have used good automotive connectors?

- Jack
What I did on the 95 was took each wire nut off, cleaned or striped the wires, put a new wire nut on and sealed it with silicon, no problems after that.
Many miles later I had to replace the brake coils, at that time I used heat shrink tubing and soldered the wires together.
PopRichie77 is offline   Reply With Quote
Old 05-01-2011, 06:53 AM   #10
Senior Member
 
PopRichie77's Avatar
 
Join Date: Aug 2010
Location: Quakertown, PA
Posts: 1,074
Send a message via AIM to PopRichie77
Default

Quote:
DO NOT pull the breakaway switch with the trailer plugged into the tow vehicle unless you want to buy a new brake controller to replace the one you just burned out. Tekonsha gives that warning in their instructions.
I have been using a TEKONSKA Prodigy brake controller since getting the 95 Hi-Lo also use it with the 2209. The first year I got the trailer inspected the guy used a helper, but after telling him that I do all my own work, he left me help every year after that. The last thing he does is check the break away, he pulls the pin and has me drive forward and each wheel slides and all is ok. He does not disconnect the 7 pin plug and it has never damaged the brake controller. I can not find that warning in my instructions. It is an older unit. I have heard that you should disconnect the plug and I will from now on.
Anyway as you said,

The best advice is to disconnect the 7 pin plug before testing the break away.

I must apologize, guess I don't read well, I did find the warning, it was on the yellow instruction paper, reads as follows,----CAUTION-- Disconnect trailer plug from the tow vehicle prior to testing a breakaway switch or you may destroy the Prodigy.
PopRichie77 is offline   Reply With Quote
Old 05-01-2011, 07:25 AM   #11
Senior Member
 
Join Date: May 2010
Location: Ohio North Coast
Posts: 850
Post

Another simple check to see if the brakes are getting 12v power to them is to use a compass. Have someone operate the brake pedal in the vehicle while you hold the compass next to the wheel hub. If power is getting to the brake, the compass needle will start moving around. No movement, no power.

Bob
__________________
2014 FR Heritage Glen 282RK
2013 F250 HD 6.7L Diesel
Formerly Owned: 1995 22D Fun Chaser & 2901L Classic
retiredcamper47 is offline   Reply With Quote
Old 05-01-2011, 08:47 PM   #12
Member
 
Join Date: Apr 2011
Posts: 6
Default brakes....

OK, we spent today eliminating the possibilities...

We have two other pickups that appear to operate the brakes in the HILO. As I mentioned in my initial post, I purchased the Tekonsha P3 controller and I don't think I mentioned it, but I paid a local utility trailer dealer to install it.


The head lights have to be turned on to provide power to the brake controller. I don't think that is right. I would think it should be wired hot all the time.

Secondly, it is intermittingly working on my truck, at times give me a positive read that it is applying brakes on trailer and at times, reading "no trailer attached".

I think the installer has a loose connection. I will give them a call on Monday and get the truck back to them to check it out.


Travis
jwwphoto is offline   Reply With Quote
Old 05-01-2011, 09:20 PM   #13
Senior Member
 
PopRichie77's Avatar
 
Join Date: Aug 2010
Location: Quakertown, PA
Posts: 1,074
Send a message via AIM to PopRichie77
Default

It definitely should not require the lights to be on, most people who wire up utility trailers do not understand what is needed for an RV trailer to function properly. Positive and negative wires have to be adequate, #10 wire to supply power for the fridge and to keep the trailer battery charged any less than this and you will have problems, besides the brake problem that you are having.
Read my last post in this thread, http://www.hilotrailerforum.com/f15/...traveling-264/
PopRichie77 is offline   Reply With Quote
Old 05-02-2011, 12:24 AM   #14
Moderator
 
Join Date: Apr 2010
Location: Napa,CA
Posts: 933
Default

jwwphoto,

You may be interested in looking at this forum thread.

http://www.hilotrailerforum.com/f24/...uestion-s-486/

I installed the Tekonisha Prodigy on my 06 Tacoma Prerunner
__________________
Les & Patricia
2006 22ft towlite (replaces 97 21TL)
2006 Toyota tacoma pre-runner 4.0 L V-6 quad cab
w/ 98 chevy Powervision towing mirrors
2017 Chevy Silverado 1500 5.3 v8 (replaces Toyota)
2 Hobie mirage pedal drive kayaks
campthewestcoast is offline   Reply With Quote
Old 05-02-2011, 08:02 AM   #15
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

If you do not have a pre-wired truck with a brake controller wiring harness plug, which would be recommended, you need to take your power straight from the battery with a 20 to 30 amp circuit breaker inline according to Tekonsha's directions. It sounds like your installer was cutting corners. You should also ground it to the battery.
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 05-10-2011, 04:41 AM   #16
Member
 
Join Date: Apr 2011
Posts: 6
Default

All is good! We got controller working and set it to setup instructions. Thanks to all for replies....

Travis W
__________________

jwwphoto is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Hi-Lo Trailers Worldwide or any of its affiliates. This is an independent, unofficial site.


All times are GMT -5. The time now is 04:05 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010
×