Hi-Lo camper travel trailer forum

Hi-Lo camper travel trailer forum (https://www.hilotrailerforum.com/)
-   General Hi-Lo camper discussion (https://www.hilotrailerforum.com/f17/)
-   -   seal question (https://www.hilotrailerforum.com/f17/seal-question-218/)

wvjeepr 04-01-2010 08:21 PM

seal question
 
I just purchased a 1994 Fun Lite and it is in very good condition with the exception of 2 spots on the seal for the top. There are 2 tears in 2 different places one where it has rubbed on the heater exhaust and one on the other side @ the refrigerator vent. Is there some way to patch this to delay having to replace the seals? Any tips on material types or procedures would be appreciated.

Harry

legomiego76 04-02-2010 09:09 AM

I also have this same issue, I have just purchaced a 18' 1995 Towlite. It is in good condition but does have a few gaps in the seal for the telescoping top. I would also like advice on how to repair seal as I don't want any water or creepy crawlers getting in.

Neal and Bev 04-03-2010 07:46 AM

I've never replaced the roof seals myself. I spoke to Sam Shields about it awhile back. Sam has over twenty years of dealership experience working on Hi-Lo's.

Sam was kind enough to give us the following outline of what is involved in the process. Of course I've added this to our library :D

In general, you have to remove the roof to replace the roof gasket (seal). It sounds like a big job, but one that is very do-able.

The roof gasket is available from the Hi-Lo factory, here's the number to call, 800-337-6490

My suggestion would be to read though the following outline and then ask any questions that you have. I hope to eventually have a more detailed outline with pictures, or perhaps even a video.

Neal

************************************************** ************
Outline for replacing the roof gasket

Removing roof:
You need 6 - 8ft 2x4's
Cut 4 of the 2x4's to fit from ground to bottom of roof.
Lower roof on to the 2x4 blocks.
Remove all screws holding woven wood walls or pocket walls.
Cut wires form lower section to roof at vent pipe and unscrew vent pipe.
Remove all guide rails.
Remove all cap boards
Remove 4 cable bolts from roof.
Fish cable inside camper.
Lower tongue jack to lowest position insert 2x4 across lower wall between lower section and roof.
Raise tongue jack to full up position and insert 2x4 between roof and lower section.
Bring tongue jack back to level

Installing new gasket:
With roof removed cut old gasket off with razor knife.
Staple new gasket in place using molding to hold in place. (molding can be made from 4 x 8 sheet of aluminum cut into strips about 1 1/2" x 8ft)
Lower roof back on lower section by reversing roof removal instructions. Reinstall cable bolts to roof reinstall, guide rails, reattach wiring, sewer pipe, interior wall screws, and cap boards.


All times are GMT -5. The time now is 08:23 AM.

Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010