Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 
 


Hydraulic lift system Hydraulic, mechanical and electrical components of the lift system
Reply
 
Thread Tools Search this Thread Display Modes
 
Old 03-02-2016, 06:26 PM   #1
Member
 
Join Date: Jan 2014
Posts: 13
Default manual lift rod location.

I have an 1992 24 ft funlite.Where is lever located and what does it look like?
__________________

woody is offline   Reply With Quote
Old 03-02-2016, 07:41 PM   #2
Senior Member
 
motorpig2342's Avatar
 
Join Date: Feb 2016
Location: Alabama (roll tide!)
Posts: 100
Default

Its in the battery compartment up front.
Attached Images
File Type: jpg Pump handle.jpg (242.6 KB, 176 views)
__________________

motorpig2342 is offline   Reply With Quote
Old 03-02-2016, 07:46 PM   #3
Senior Member
 
motorpig2342's Avatar
 
Join Date: Feb 2016
Location: Alabama (roll tide!)
Posts: 100
Default

This small "bolt" here has to be turned all the way in clockwise or it wont go up manually. Turn it counter-clockwise slowly to lower it.
Attached Images
File Type: jpg valve.jpg (244.5 KB, 105 views)
motorpig2342 is offline   Reply With Quote
Old 03-02-2016, 08:37 PM   #4
Site Team
 
JackandJanet's Avatar
 
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,527
Default

Motorpig is showing you the part on the pump you stick the rod in to allow you to move it back and forth.

It sounded like you were asking about the rod itself. If you have one, it's normally sitting in the battery compartment as a loose item. It's about 18" long, as I recall, with a handle on one end. It looks like a round pipe that will fit into the pump fitting.

If you don't have the rod, you can easily substitute a length of iron water pipe if it will fit into the pump fitting.

- Jack
__________________
Hi-Lo 1707T - Tire Minder TPMS on Tow Vehicle and Trailer, 300W Solar Battery Charger, Equal-i-zer WDH, Progressive Dynamics Converter, Fan-Tastic Fan, LiFePO4 battery 12V DC Electrical System
2014 F150 Platinum 4x4 3.5L EcoBoost SCrew
JackandJanet is offline   Reply With Quote
Old 03-03-2016, 06:27 PM   #5
Member
 
Join Date: Jan 2014
Posts: 13
Default manual lift

This pic is my unit.The rod in pic seems to be permanent
Attached Images
File Type: jpg view one[1].jpg (180.7 KB, 131 views)
woody is offline   Reply With Quote
Old 03-03-2016, 06:58 PM   #6
Senior Member
 
motorpig2342's Avatar
 
Join Date: Feb 2016
Location: Alabama (roll tide!)
Posts: 100
Default

I'm new to this stuff, but looks like the pump has possibly been changed out to one that does not have a manual why to do it. What brand is the pump? Is it a monarch?
motorpig2342 is offline   Reply With Quote
Old 03-03-2016, 07:19 PM   #7
Senior Member
 
Join Date: Jul 2010
Location: central Virginia
Posts: 581
Default

Not all pumps on the HiLos had a manual pump. You had to pay extra for it. It also came standard on most classic models. The small rod in your picture is the manual lowering valve. If it has not been activated in a long time it may be stuck and will need a little force to move it. Just try moving it sideways or up and down. You will need to lift the top with the pump enough to get the weight off the safety bar and have someone pull the safety bar cable then activate the lowering lever in order to manually lower the top.
__________________
Jim L & Faye
2805C
2003 Silvarado diesel crew cab
2017 Silvarado, crew cab 1500 6.2L gas w/ 8 speed tranny
central VA
JIM L is offline   Reply With Quote
Old 03-03-2016, 07:34 PM   #8
Member
 
Join Date: Jan 2014
Posts: 13
Default

Thank you all.
woody is offline   Reply With Quote
Old 03-04-2016, 09:55 AM   #9
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

Quote:
Originally Posted by motorpig2342 View Post
I'm new to this stuff, but looks like the pump has possibly been changed out to one that does not have a manual why to do it. What brand is the pump? Is it a monarch?
That's the earlier model pump.
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 03-04-2016, 10:02 AM   #10
Moderator
 
RichR's Avatar
 
Join Date: Feb 2010
Location: NW PA
Posts: 3,386
Default

Quote:
Originally Posted by woody View Post
This pic is my unit.The rod in pic seems to be permanent
Your pump does not appear to have a manual lift. That was an option or was not available back then.
__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU
RichR is offline   Reply With Quote
Old 09-29-2016, 08:35 AM   #11
Member
 
Join Date: Sep 2016
Location: Houston, Texas
Posts: 81
Default

I have the exact same issue. I just acquired a 1992 Funlite and the previous owner towed it in the raised position after someone stole the battery
lisakjcowgirl2016 is offline   Reply With Quote
Old 09-29-2016, 08:36 AM   #12
Member
 
Join Date: Sep 2016
Location: Houston, Texas
Posts: 81
Default

my unit is exactly like this one. did you ever get the answers you were looking for?
lisakjcowgirl2016 is offline   Reply With Quote
Old 09-29-2016, 09:19 AM   #13
Member
 
Join Date: Sep 2016
Location: Houston, Texas
Posts: 81
Default

I have the same exact problem. I just acquired a 1992 Funlite and the prior owner towed the trailer in the raised position once someone stole the battery. now I cannot get the top to lower. any suggestions would be greatly appreciated. I am a newbie and really trying to restore this camper.
Attached Images
File Type: jpg 20160929_080159.jpg (166.7 KB, 34 views)
lisakjcowgirl2016 is offline   Reply With Quote
Old 09-29-2016, 11:04 AM   #14
Senior Member
 
hilltool's Avatar
 
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
Default

You need to get the weight of the trailer up off the safety bar first. Hook up to good battery and tryraisingit an inch to start. Release safety bar ( usually a little cable you pull next to raise/lower switch. ). Then while holding cable press down button. If you have bigger issues and buttons don't work let us know.

Rick
__________________
2201 TL

2010 Nissan Titan king cab SE
4x4
hilltool is offline   Reply With Quote
Old 09-30-2016, 02:28 PM   #15
Member
 
Join Date: Sep 2016
Location: Houston, Texas
Posts: 81
Default

You need to get the weight of the trailer up off the safety bar first. Hook up to good battery and tryraisingit an inch to start. Release safety bar ( usually a little cable you pull next to raise/lower switch. ). Then while holding cable press down button. If you have bigger issues and buttons don't work let us know.

Rick
____________

Thanks Rick I will try that and let you know how it turns out.

Have a great day
lisakjcowgirl2016 is offline   Reply With Quote
Old 10-05-2016, 01:39 PM   #16
Member
 
Join Date: Sep 2016
Location: Houston, Texas
Posts: 81
Default

Thank you so much. I followed your instructions and was able to get the trailer to come down. Now I am going to replace all the faded out Side Marker Lights. So glad I found this forum or I would have been "STUCK LIKE CHUCK"

Thank you once again.
lisakjcowgirl2016 is offline   Reply With Quote
Old 10-05-2016, 05:01 PM   #17
Senior Member
 
hilltool's Avatar
 
Join Date: Feb 2012
Location: Wisconsin
Posts: 1,256
Default

Glad it was simple. Electrical is usually the most common issue when not being able to raise or lower. So, now, make sure you lubricate all the cables once or twice a year as well as grease the hydraulic "ram". Check the library for links on how to do this.

Rick
__________________
2201 TL

2010 Nissan Titan king cab SE
4x4
hilltool is offline   Reply With Quote
Old 10-08-2016, 12:22 PM   #18
Member
 
Join Date: Oct 2016
Location: Las Vegas
Posts: 5
Default

Thanks, Jack
jag70r is offline   Reply With Quote
Old 05-20-2017, 11:14 AM   #19
Member
 
Join Date: May 2017
Location: Pa
Posts: 3
Default

afternoon! we are new to owning a hilo. we took delivery of it last night! not sure i got a good deal... guy claimed we could tow it home in upright postion trip was 130 miles from picking it up to home. he claimed reason it wasnt going down is solenoid is shot... so this morning hubby is on his way to get one! i'm stressed out bc i've always wanted a hi lo.. btw its a 1983 i'll post pics later! he lied to me about his camper in so many ways but we are willing to give this baby a second life!
Strinetime76 is offline   Reply With Quote
Old 05-20-2017, 07:06 PM   #20
Member
 
Join Date: Sep 2015
Location: Janesville,Wi
Posts: 41
Default

Somebody forgot to read the manual on not having it sit on the safety bar!!!!!
__________________

2005retired2005 is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Hi-Lo Trailers Worldwide or any of its affiliates. This is an independent, unofficial site.


All times are GMT -5. The time now is 07:10 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010
×