Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
 
 


Plumbing, Water, Tanks and Waste Fresh water, storage tanks, faucets and fixtures.
Reply
 
Thread Tools Search this Thread Display Modes
 
Old 07-21-2020, 05:56 PM   #1
Member
 
Join Date: Sep 2015
Location: Red Lodge, Montana
Posts: 15
Default fixing black water release mechanism

We have a 2007 17T Hi Lo. As we tried to release the black water, the handle came off and the black water did not release. There is also a leak at the black water tank where the pipe comes down from the tank. Does anyone have recommended solutions for these two problems?

Thank you.
__________________

mbrown is offline   Reply With Quote
Old 07-21-2020, 10:44 PM   #2
Site Team
 
JackandJanet's Avatar
 
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,527
Default

Yes, you can change the valve that empties the black water tank. I did this on mine. Got the replacement dump valve from etrailer.com. They're not expensive and not particularly hard to replace. Your problem though, is that you have waste water (and other contents) still in your tank, if you couldn't empty it. As you remove the old valve, the contents of the tank will start leaking out around the valve fitting. I don't know what to tell you to do, except have a big bucket handy and maybe just loosen it some, until the bucket gets nearly full, then tighten it up again so you can dump the bucket in your toilet. Repeat as necessary until the contents are drained. If you have "solids" in there, this will not get them out, but maybe you can dump them once you have changed the valve. I'd lubricate the new slide with plumbers grease before you insert it.

The leak at the drain pipe connection to the black tank is also easy to fix. I repaired mine by coating the entire joint with ABS cement (bought at Home Depot), then pressing fiberglass cloth onto the still wet cemented areas and applying more ABS cement over the entire "patched" area. The fiberglass cloth makes a very strong patch and it adheres to the tank and pipe well with ABS cement. I think I repeated this process once more after the first application had dried.

There are numerous posts on these problems in the Plumbing section.

- Jack
__________________

__________________
Hi-Lo 1707T - Tire Minder TPMS on Tow Vehicle and Trailer, 300W Solar Battery Charger, Equal-i-zer WDH, Progressive Dynamics Converter, Fan-Tastic Fan, LiFePO4 battery 12V DC Electrical System
2014 F150 Platinum 4x4 3.5L EcoBoost SCrew
JackandJanet is offline   Reply With Quote
Old 07-22-2020, 10:30 AM   #3
Member
 
Join Date: Sep 2015
Location: Red Lodge, Montana
Posts: 15
Default Thank you

Thanks. I will verify the part and get it ordered
mbrown is offline   Reply With Quote
Old 07-22-2020, 11:12 AM   #4
Site Team
 
JackandJanet's Avatar
 
Join Date: Jul 2010
Location: Pine, AZ
Posts: 4,527
Default

I had a thought, is the rod that connects to the valve visible? If so you could possibly grasp it with locking pliers and pull on them to open the valve. It would be a lot more "pleasant" to change the valve if the tank was empty and cleaned. *grin*

I think that rod end is threaded too, now that I think of it. Possibly, you could thread a nut on to it to give the pliers something to "grab", or, maybe you could put something large onto the rod ahead of the nut that would give you something to pull on with your hands.

- Jack
JackandJanet is offline   Reply With Quote
Old 07-23-2020, 05:53 PM   #5
Member
 
anchorwood's Avatar
 
Join Date: May 2013
Location: Southeastern Idaho
Posts: 87
Default

I had the handle on the dump valve break on an old motor home we had. I think half the plastic handle was gone when we bought the unit, so I didn't trust the one side that was left. As Jack suggested, I had the vise-grips handy and a good pair of gloves to pull them ready when the other side broke. I think I used that solution for a whole summer.

Getting a new valve on was much better when I finally did it. Plumber's grease, great idea Jack. Any way to make this process easier, I'm all for it.
__________________
Roger
1999 22L Classic
2008 Toyota 4Runner V6
McKesh Mirrors
Andersen Hitch
anchorwood is offline   Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Hi-Lo Trailers Worldwide or any of its affiliates. This is an independent, unofficial site.


All times are GMT -5. The time now is 01:10 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010
×