Water Heater Drain Valve Installation
1 Attachment(s)
Hi,
In order to make winterizing easier I replaced the water heater drain plug with a valve. I used the following brass fittings, as well as some Teflon tape: 1/2 X 1/4 bushing, 1/4 close nipple, and 1/4 ball valve. I assembled everything on the bench and temporarily removed the valve handle for installation clearance. Installation was not hard, but I had to be careful not to cut my hands on the many sharp metal surfaces on the water heater. I ended up clocking the valve handle upside down and slightly bending it to get enough clearance to operate it. Raul |
All times are GMT -5. The time now is 12:09 PM. |
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010