Add'l bed support
 

We found out the hard way that the supports for the bed/table in our 2506C
were minimal at best. Bought some angle aluminum at Home Depot, did a little
filling to round the corners and added some pads, to give some added support. So we don't end up on the floor!

Your Idea is a good one! At 6'4" and 260#'s, I rode our table/bed to the floor one night. Since it's just my wife and I and the dog, the dinette bed is now happily claimed by our American Bulldog. Our loss is her gain!

We also had to bulk up our table/bed like you did, in addition we added quiet a bit on the bottom of the table top. It doesn't show from the top, but is much more sturdy now.