camper.jpg
Got a great deal on this 1992 in great shape
just sayin Hi from Dallas GA.

camper dodge.jpgVery adequate tow rig

HiYa from NC

__________________
TV-2012 Ford F-150
2013 Forest River Flagstaff 27RLWS
NC

Welcome from the north coast. Sweet looking rig! Hopefully it is the slope in the road causing the illusion, but the front of the trailer looks a bit low on the hitch.

Bob

__________________
2014 FR Heritage Glen 282RK
2013 F250 HD 6.7L Diesel
Formerly Owned: 1995 22D Fun Chaser & 2901L Classic

It was low on the hitch to keep the rear from dragging backing up the hilly driveway . its raised to tow. a pain but something i have to do

You just have to do what you have to do to get the job done. 👍🏻

Bob

__________________
2014 FR Heritage Glen 282RK
2013 F250 HD 6.7L Diesel
Formerly Owned: 1995 22D Fun Chaser & 2901L Classic

Nice looking trailer! congrats. If you ever have the inclination and/or money and/or weariness of of dragging the rear end------I added three inches clearance to mine by having the axles removed and then had spacers welded in and the axles re-attached. makes a difference- especially on hilly strip malls in places like Georgia where you bang going in and out of gas stations.

Welcome to the forum!

Rick

__________________
2201 TL

2010 Nissan Titan king cab SE
4x4

Yes I have been considering doing a spring over axle flip. still figuring everything out about the Hi Lo. 1st thing is new tires and grease the bearing buddy,s I have gone over all the plumbing/tanks and pump just had to tighten a few wing nuts on the faucets but i need a new grey tank cap. the a/c is ice cold. haven't checked anything yet that works off propane but for what I paid if anything needs attention it will be ok. the camper is almost in pristine condition. the elderly gentlemen I bought it from hardly used it at all

Looks like you picked up a good condition unit. Was it stored inside? I would recomend that you have your new tires balanced at the time of install. Lots of friendly folks on the forum that can answer any questions that you may have.

Rather than grease the bearing buddy I recommend that you pull the hubs and bearings, clean them, inspect, and repack.

__________________
My Great Wife Joyce
2018 Jayco Jay Flight 21QB
Formerly owned 1705T and 2310H
2012 F150 4X4 SuperCrew EcoBoost w/Leer Cap
Reese WD Strait-Line Hitch
Amateur Radio K3EXU

What Rich said. You won't find many fans of Bearing Buddies on most RV forums. The general rule is what Rich said.

__________________
Jim in Memphis
Wife of 45 years is Brenda
Recently sold our 1997 24' Classic
2014 Ford F-350 6.7 Diesel Crew Cab

OK, I'll bite, So what are Bearing Buddies and why are they bad?

__________________
Greg
2004 4x4 Chevy Tahoe
Former owner of a 2407T

They're a way to grease your wheel bearings without taking them apart. You insert the grease though a grease fitting until it starts to ooze out. They were developed for trailers whose axles regularly go underwater like boat trailers. These need more frequent bearing lubrication replacement.

The biggest disadvantage of them is that you don't inspect your bearings for wear. And, you may have dirt inside that is not cleaned out.

- Jack

__________________
Hi-Lo 1707T - Tire Minder TPMS on Tow Vehicle and Trailer, 300W Solar Battery Charger, Equal-i-zer WDH, Progressive Dynamics Converter, Fan-Tastic Fan, LiFePO4 battery 12V DC Electrical System
2014 F150 Platinum 4x4 3.5L EcoBoost SCrew

Looks like a really good unit. Welcome from Chattanooga and Cartersville.

__________________
Don and Lou
2703 TowLite
'97 Chev Suburban 2500 Diesel
Tennessee/Greenest state in the land of the free
moonstruckblog.wordpress.com

Moonstruck,
My daughter lives in Cartersville! Small world. Lives in Cass Station, that's one reason for our liking the Lake camping. Just adding a note.
Tree

__________________
Treeclimber
2703 Tow Lite
2002 Escalade
Bonita Springs, Fl. &
Andrews, NC