Coachmen 2146BHX
On a trip right now and when we shower the tub is holding water. If left over night it does eventually drain, bit obviously there is a clog somewhere. We are at a full hookup site. Gray tank has been emptied and didn’t help, no issues with tank emptying. There are no other...
My battery/solar setup has been working flawlessly since 2024 and was powered down during this past winter until a month ago. With my setup (listed below), I no longer need to plug into shore power to charge my system.
Today I found the batteries dead -- no power at all in my system.
I checked...
I want to add a new 100ah Lithium battery to replace my old lead acid battery that is crap.
What do I need to do if anything? Do I need to replace my converter with a more Lithium friendly one?
I have a 560ah solar system with a 3000W inverter (all Victron hardware), but it is on a separate...
I have seen a couple of threads that talk about this topic, but more on the side of troubleshooting. I have a 2025 Rockwood Mini Light 2509S And the majority of the places we are staying do not have convenient spots to stop and fill the water tank on the way in. My question I pose is can I use...
When I run the AC, I have to push the slider all the way up to 90° and it still wont shut off. It's like a freezer. Is there an adjustment I can make (I looked, but I cant find anything on the board). Is there a thermostat you can recommend that is more accurate and an equivalent replacement...
🚨Skoolie Experts, Rust Gurus, and YouTube Mechanics!🚨
Alright y’all, I need your experienced eyeballs on something before I make a financially questionable decision and end up with a very expensive backyard planter. 😅
I’m a first-timer (read: bright-eyed and dangerously optimistic) looking to...
My valve is in a spot that isnt exactly easy to get to so Im thinking of replacing the valve with one with a cable. Since my RV is permanently set up I can just mount the cable to the side panel and it will be fine. I have no idea who makes the best one as there are crappy reviews of Camco...
We just picked up our new-to-us 2025 Geo Pro 19FD, and after the 10-minute, 6-mile drive home, discovered the right side of the microwave isn't secured to anything; the left side is fine. Is this a common issue? Any tips, hints, or suggestions on how to properly secure it?
The camper is...
Our first generation GSWH-1 was a great on-demand water heater for years. Partnered with the Shower Miser it was perfect for boondocking. About 3 years ago I started having to 'aggie-engineer' fixes to keep it going (with Girard's help). Also, the copper tubes around the heat stack had enough...
Hey everyone,
New 2024 Rockwood MiniLite 2109-s that came pre-wired for the Furrion camera system. I have a Digital rear view mirror in my Ram 1500; however, and so I want to run a camera cable to the hitch in order to plug in and utilize my DRVM. I've been looking for ways to get the Coax...
2022 Alta 1900mmk. I need to replace this cover strip but I don't have a clue about what to call it in a search. It covers the screws that go through a metal track which secures the front fiberglass to the side walls. Anyone know the name of this part? Suggestions for a vendor?
I wanted to share a quick and easy hack for anyone who is fed up with how loud the air conditioners are on our Travel Trailers and RV's.
It's annoying while trying to sleep, or while trying to have a conversation or listen to music during dinner or relaxing. Even with that sliding vent closed...
I just purchased a 2024 e-pro, and once I got home from the dealership, I noticed some sticky goo-type liquid on the front of the camper. After I looked closer, I noticed the clear silicone-type covering for the LED lights on the front cap had melted away. I suppose the sun plays havoc on this...
I'm sitting here in the camper on another rainy Saturday morning. I need a creative mind. We are at a seasonal site, and the way we are situated the sun shines in the side under our awning onto the deck and makes it impossible to sit there because of glare and the heat.
What I am trying to...
In another thread someone mentioned that batteries in parallel should have their own fuse should BMS fail during "catastrophic failure. Also that they should be as close to the batteries themselves as possible.
I just finished installing such fuses on my two Battleborn GC-3 batteries. Another...
Aggravated with fridge going into safety and not cooling for 6- day trip. Repeatedly reset fridge and ended up defrosting coil with wife's hairdryer. Worked for about a day and refroze. When I got home today, I removed the inner plate inside the freezer and tried to unplug a connector with a...
Trailer is around 5 years old and still on the original suspension but it needs some work, trying to get some thoughts. I've had a couple of the hanging brackets sheer off over the last couple of years, but other than that... not many problems.
With this setup, are there bushing in all the...
Our Forester is not very quiet, so I decided to installing some soundproofing and and heat shield. As I was taking up the floor mat, it quickly became obvious the underneath was very wet. After I removed the mat, I used my shop vac to remove a lot of water and hung it up to drain. I inspected...
Does anyone know the size of the push in grease fitting on the end of the Dexter Ez-Lube 5000 lb. axle.Mine came off with the grease gun nozzle and it appears it was installed on an angle stripping half of the annular rings.Thanks in advance for any help.
I want to find this same style of bracket so I can install it next to my sink and use the shelf in multiple places. Can someone please tell me where to buy one?
Last weekend, during a full hookup camping trip, all the plugs went out..except the one that has the GFCI receptacle.
Using tools I brought along, I removed the GFCI outlet from the wall. I discovered a burned black hot wire and heat damage on the back of the outlet. (lower left hole on the gray...
The clear coat has been peeling from the plastic fender skirts on my 2014 FR Wildcat Maxx 27RLS Travel trailer. (See photos) The plastic skirts are in decent condition, but I’d like to re-spray the clear coat to make them look new. Do I remove the clear coat first? The fender skirts have a kind...