As an alternative to a rubber roof, please have a look at this thread: https://www.hilotrailerforum.com/f35...374/#post56860 starting at Post #4 where Rob, who was formerly with J&R Repair recommends a tape product. Note that he specifically recommends against rubber roofs.
- Jack |
Roofs
We had a rubber roof on our 1990. Just caught the start of a leak and used a 25ft.rubber roof patch kit. DH used the appropriate roof coating. Also used externa bond tape. The current owner is a RV tech and states he hasn't had to do anything in the way of repairs. I read the post from J&R. Wish i had seen this before Dh used externa bond tape.
|
Quote:
Either way - salvage the skin and reuse it as the outer shell. It's already the right shape. The roof is different. The aluminum roof can pit and corrode and I cut away large parts of my own as I went through it. Then with new foam and plywood layers in place, re-skinned it with peel-stick aluminum roof product (same as suggested in the reply above - so what you see on the rebuild pictures is this same product). So far so good on it holding, and I keep an eye on it. |
Thank you all for the information
I appreciate the extra info and advice. We're talking about the trailer and what we want to do. In my mind, we either fully commit to the project, or cut bait and go. If we move forward, I'll post pics here on this forum and hopefully it won't illicit too much ptsd in those who've done this before.
|
Keep us posted!
|
Quote:
When you used the 4x4 timbers to stiffen your frame rail, why did you cut the notch on the top side of the timber? I understand why you cut the bottom side 1”x1” to cradle/support frame, but I am curious why cut the top 1”x1”? Was it have a place for the insulation board to fit and to slide the interior panel into it to hold it? Or to lighten it some? I was considering not cutting the top side to keep the integrity of the 4”x4”. Just curious on your thoughts. |
Quote:
In hindsight, thinking through what you’re saying a bit, I could have notched the foam and not cut the 4x4 on the top there. I could see that working fine. Nice improvement, and saves some work with the saw too! I guess the only thing to be careful of is to make sure the foam with notch has a nice matching straight line so that as it is all glued up, the strength of the wall is maintained as much as possible. Should be doable for sure though. |
Ok, I am replacing the beam full length on both sides, so I think I will just notch the lower frame area.
Thanks for your reply!! And for all the work you went through to document the whole process, it is really helping me out and giving me ideas (ideas could be a good thing or a bad thing, time will tell.) :) |
You’re very welcome, and I’m just happy this thread and those picture are helping out from time to time. Good luck on your continued rebuild, these are worth saving if we can :)
|
All times are GMT -5. The time now is 04:37 AM. |
Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
HiLoTrailerForum.com Copyright 2010